Designed to make creating a custom Plug and Play (PNP) solution for your V5/V6 WRX as easy as possible, without needing to modify the factory harness.
Kit Includes:
AMP ECU Header
Custom PCB
3D Printed Housing
Features
To make assembly as simple as possible, the PCB has a number of features. Each ECU pin is labelled on both sides of the board, making it easy to ensure you have the wire in the correct location.
Each ECU pin goes to a spare pin for soldering your own wire to.
All 12V pins are joined and there are extra 12V locations to connect to.
All Ground pins are joined and there are extra Ground locations to connect to.
All Sensor Power (+5V) pins are joined and there are extra Sensor Power locations to connect to.
All Sensor Ground (SGND) pins are joined and there are extra Sensor Ground locations to connect to.
There is a small (58) proto board area for adding extra electronics and components to if these are needed in your project. Each side of this has a 12V and Ground rail for ease of use.
The case has two mounting tabs, as well as a cable strain relief. The relief is designed to take a cable tie and clamp the wiring in place. The top housing has an opening at this point for running the wiring.
This is an example of a completed kit which has been used to create a Motec PNP setup.