Galvanised Malleable Iron End Cap | BSP Thread | 3/4″ to 3″ Pipe Fittings

The Galvanised Malleable End Cap is a simple, solid fitting used to close off the end of a pipe. Made from malleable cast iron to ASTM A-197 and ASTM A47, each cap has a hot-dip galvanised coating to ISO 1461 to help it stand up to outdoor and rural conditions. Sizes run from 3/4 inch (LC20) through to 3 inch (LC80), making it a handy fit for a range of pipe work needs.

These caps are a good choice for farm water lines, irrigation systems, compressed air runs, and fuel or gas line work. They thread straight onto a BSP pipe end for a pressure-tight close-off, and they comply with Australian Standards. Keep a few on hand and you will always have a quick way to cap off an unused port or pipe end.

Features

• Malleable cast iron body to ASTM A-197 and ASTM A47 for reliable strength
• Hot-dip galvanised coating to ISO 1461 to help resist rust and corrosion
• BSP thread for a pressure-tight close-off on pipe ends
• Rated to 150PSI working pressure
• Designed to EN 10242:1994 standard
• Suits water, compressed air, irrigation, and fuel or gas line use
• Complies with Australian Standards

A useful fitting to have in the workshop or on the ute, this end cap could seal off open pipe ends quickly and cleanly across a range of farm and rural setups.